Biosystems Bts 350 | User Manual !!better!!

BioSystems BTS-350 User Manual an essential technical resource for operating one of the few semi-automatic analyzers on the market powered entirely by LED optics Manual Overview & Structure

4. Where to find the genuine PDF manual

E-102

| Error Code | Meaning | Immediate Action | |------------|---------|------------------| | | Cuvette not detected | Open lid, reseat cuvette wheel, run Cuvette Check | | E-205 | Aspiration failure | Check reagent probe for clogs. Clean with probe wash solution (not alcohol). | | E-309 | Temperature out of range (34–38°C) | Allow 15 min warm-up. Check incubator block for debris. | | E-417 | Lamp low energy | Run lamp intensity test. Replace if <40% of reference value. | biosystems bts 350 user manual

• Sensors: Catalytic bead (LEL), Electrochemical (O2, H2S, CO).
• Battery: 3x AA Alkaline or NiMH rechargeable.
• Run Time: 12-14 hours (alkaline).
• Alarms: Audible (90dB), Visual (red LEDs), Vibrator (optional).
• Data Logging: Yes, IR download.

Thermal Control

: The Peltier system maintains temperatures at 25°C, 30°C, and 37°C. Thermal Control : The Peltier system maintains temperatures

: An optional battery pack provides up to 2 hours of power in case of a failure, preventing data loss. Maintenance & Troubleshooting Tips Sensors: Catalytic bead (LEL)

1. Introduction

1. Power on → Enter calibration mode (press MODE + POWER – exact combo in manual).
2. Apply gas → Wait for reading to stabilize.
3. Unit auto-adjusts span.
4. Return to fresh air → Verify zero.