Bosch Me711 Pinout 🔖

The Ultimate Guide to the Bosch ME7.1.1 Pinout: Signals, Power, and Sensors

Boot Mode

For advanced operations like IMMO off or deep recovery, the ECU often needs to be put into . This typically involves:

Communication Protocols

: The ME7.1.1 supports multiple communication standards, including K-line , CAN-bus (high/low), and BDM (Background Debug Mode) for full chip access. bosch me711 pinout

• Row A: Top row (Pins 1–29 typically)
• Row B: Middle row (Pins 30–58 typically)
• Row C: Bottom row (Pins 59–88)

ST10F275

Connecting a specific pin (often the processor's boot pin) to ground via a resistor (typically 1k to 5k ohm) during power-up. The Ultimate Guide to the Bosch ME7

Bosch ME711 Pinout: The Complete Wiring Guide for VAG 1.8T & 2.0 FSI ECUs

Ignition Switched Power (+12V - Terminal 15):

Pin 21 and 62 .

• Label on case: "Bosch ME711 / 0261209xxx" or "0 261 209 xxx"
• Physical shape: Aluminum case, 121-pin connector, two 10mm bolts holding the harness plug.
• Common part numbers: 0261209605 (Audi A4 1.8T), 0261209875 (VW Passat 1.8T)