Commax Dp-ra01 Installation - Manual

COMMAX DP-RA01

The is a wall-mounted room unit (handset) designed for single-house doorphone systems. It primarily functions as an intercom to communicate with a door station and control an electronic door release. Pre-Installation Safety Guidelines

1 (or +12V)

| Terminal | Standard Function | Wire Color (Common Practice) | | :--- | :--- | :--- | | | Positive power input | Red | | 2 (or GND) | Common ground / negative | Black | | 3 (or AUDIO) | Audio signal from door unit | White or Yellow | | 4 (or CALL / TALK) | Call button signal / voice switch | Blue or Green | | 5 & 6 | Secondary door release (rarely used) | Optional | commax dp-ra01 installation manual

If you encounter a problem not listed here, check your connections with a multimeter first. Nine times out of ten, the issue is a loose wire or reversed polarity. Happy installing. COMMAX DP-RA01 The is a wall-mounted room unit

Do not skip this step. Installing a door phone involves low-voltage electricity, but mistakes can fry the camera or the monitor. Separate the Mounting Bracket: If the DP-RA01 has

1. Separate the Mounting Bracket: If the DP-RA01 has a detachable backplate, remove it by unscrewing the bottom screw or sliding the unit up.
2. Mark the Holes: Hold the bracket against the wall. Use a level to ensure it is straight. Mark the screw holes with a pencil.
3. Drill: Drill the holes. If you are on

• Do not run door phone wires parallel to AC power lines (keep >30 cm / 1 ft apart).
• Do not use CAT5/6 twisted pair for long runs (>50 m) without shielding – use proper door phone cable.
• Disconnect power before connecting or disconnecting wires.

• VR1 (V dial): Brightness control. Rotate clockwise to increase video brightness.
• VR2 (S dial): Call volume control. Rotate clockwise to increase ringtone volume.