Control Universal Articco Th-msur-40 Manual -
Articco TH-MSUR-40
The is a 4-in-1 universal remote capable of controlling Air Conditioners (AC), TVs, DVDs, and Audio systems. Setup & Programming Methods
- Warranty: 2 years from date of purchase against manufacturing defects.
- For technical support, contact your local Articco distributor with the model number (TH-MSUR-40) and serial number.
- Power: Ensure the supply voltage (100-240V AC, 50/60Hz) matches the rating on the side panel.
- Installation: Must be installed by a qualified electrician. Do not expose to water or corrosive gases.
- Disconnect: Always disconnect power before wiring or cleaning the unit.
You're looking for a solid report related to the control universal Articco TH-MSUR-40 manual. Here's some information that might be helpful: control universal articco th-msur-40 manual
: Displays the current operating mode, clock, and temperature. Memory Retention Articco TH-MSUR-40 The is a 4-in-1 universal remote
- Press the Set button once.
- The display will flash the current target temperature.
- Use the Up/Down arrows to adjust to the desired box temperature (e.g., 35°F / 2°C).
- E0 / EE: Internal EEPROM failure (replace controller).
- E1: Room sensor (S1) shorted or open. Check wiring terminals 3-4.
- E2: Evaporator sensor (S2) faulty. The unit will run defrost on a timed basis only.
- E3 / HI: High-temperature alarm. Compressor has run too long and setpoint not reached.
- LO: Low-temperature alarm (freeze protection).
- — (three dashes): Probe reading out of range (e.g., -50°C when sensor is disconnected).
Category:
HVAC / Refrigeration Controls Target Audience: Technicians, Maintenance Personnel, Engineers Warranty: 2 years from date of purchase against