Genetec Config Tool Default Password [updated]

Genetec Security Center

For a standard installation, the default Admin user is created with a blank password . You simply enter Admin as the username and leave the password field empty to log on for the first time.

If admin / admin fails:

• Step 1: Plug a laptop into the same Layer 2 network segment as the Genetec appliances.
• Step 2: Download the freely available Genetec Config Tool (no license required for discovery).
• Step 3: Run discovery. The tool finds every appliance by MAC prefix.
• Step 4: Right-click -> "Login." Type genetec.

7. Conclusion

Some common issues with the Genetec Config Tool include: genetec config tool default password

Case-sensitive note: The password is typically all lowercase, though older versions (pre-2015) occasionally used Genetec with a capital G. For modern versions (Security Center 5.x, 6.x, 7.x, and the current 8.x), the standard is genetec . Genetec Security Center For a standard installation, the

For security, Genetec strongly recommends changing this password immediately after installation. Depending on the specific Genetec appliance or service you are using, the default credentials may vary: Default Credentials by Component Config Tool / Security Desk : Username / Password Synergis Cloud Link : Username / Password (you must change this on the first logon). Streamvault Appliances Server Admin (Emergency Access): Password genetecfactory Streamvault Mobile App : Default password How to Change the Admin Password Step 1: Plug a laptop into the same

• Contact your system administrator or IT/security team for credentials.
• Refer to official Genetec documentation or your product support agreement for setup procedures.
• If the device/software is owned by you and you’ve lost access, contact Genetec Support for verified recovery steps.

Genetec Security Center

For a fresh installation of , the default login for the Config Tool is typically: Username: Admin Password: [Leave Blank] Important Variations: