Ibm Ts3310 Admin Account Locked
Getting locked out of an IBM TS3310 Tape Library administrator account can halt backup operations and prevent critical configuration changes. Because this library uses a web-based interface (Remote Management User Interface or RMUI) and a physical operator panel, there are several ways to regain access. 🛠️ Immediate Solutions for a Locked Account
If you are not in a rush, simply wait for an hour and try logging in again with the correct credentials. Method 2: Resetting via Physical Operator Panel ibm ts3310 admin account locked
- Default user:
admin - Default password:
secure(orpasswordon older units)
This article provides the definitive guide to understanding why the lockout happens, the step-by-step recovery methods (including the rarely-documented hardware reset), and a strategic plan to ensure it never happens again. Getting locked out of an IBM TS3310 Tape
- Open a telnet connection (yes, telnet—service ports often use unencrypted legacy protocols) to
192.168.0.5on port23. - Login Credentials:
service/service!23(Note: This is a well-known backdoor for IBM tape libraries, including the TS3310 and TS3100/TS3200 series. If changed, your organization may have a custom password.)
- Web interface login shows: “User account is locked. Contact system administrator.”
- Operator panel login rejects admin password with no immediate lock message but further attempts fail.
- SNMP or email alerts:
User account lockedevent.
Contact IBM support if:
Configure the library to send an alert when an account locks: Default user: admin Default password: secure (or password
User:
admin | Password: adm001 (specifically for libraries upgraded to firmware 1.90+) . 🛠️ Advanced Recovery (Service User)
