Code A910 Exclusive — Yaskawa Error
Yaskawa Error Code A910: Understanding the “Exclusive” Alarm
Title:
Overload Warning (Electronic Thermal O/L) Severity: Warning / Alarm (The drive will typically continue to operate unless parameter settings force a stop, but the fault must be cleared to reset the monitor).
Re-evaluate Sizing:
If the error persists under normal operation, you may need a motor with higher torque capacity. yaskawa error code a910 exclusive
A.910 error code
On a Yaskawa Sigma-7 servo drive, the specifically indicates an Overload Warning . This code is exclusive in the sense that it acts as a preemptive alert, appearing before the drive triggers a more severe, machine-stopping alarm like A.710 or A.720. What is Happening? If using the keypad to JOG: Disconnect the
- If using the keypad to JOG: Disconnect the external PLC command cable or ensure no "Run" signals are active on the input terminals.
- Check Parameter
o2-01(or similar depending on series) which dictates the frequency reference source and run command source.
High Ambient Temp:
Excess heat inside the SERVOPACK panel (typically should be below 55°C). Recommended Solutions High Ambient Temp: Excess heat inside the SERVOPACK
, causing it to trigger even during normal (but heavy) operation. 【安川電機】e-メカサイト ✅ Immediate Troubleshooting Steps Monitor Cumulative Load: Check the drive's monitor mode to see the Cumulative Load Ratio
Cooling:
Check if panel fans are working or if the heat sink is obstructed.
